V3.0.0
4.1 Prepare your PC to configure the WLAN Broadband Router
For OS of Microsoft Windows 2000/ XP:
1. Click the
Start
button and select Settings, then click
Control Panel
. The
Control Panel
window will
appear.
2. Move mouse and double-click the right button on
Network and Dial-up Connections
icon. Move
mouse and double-click the
Local Area Connection
icon. The
Local Area Connection
window will
appear. Click
Properties
button in the
Local Area Connection
window.
3. Check the installed list of
Network Components
. If TCP/IP is not installed, click the
Add
button to
install it; otherwise go to step 6.
4. Select
Protocol
in the
Network Component Type
dialog box and click
Add
button.
5. Select
TCP/IP
in
Microsoft of Select Network Protocol
dialog box then click OK button to install the
TCP/IP protocol, it may need the Microsoft Windows CD to complete the installation. Close and go
back to
Network
dialog box after the TCP/IP installation.
6. Select
TCP/IP
and click the properties button on the
Network
dialog box.
7. Select Specify an IP address and type in values as following example.
IP Address:
192.168.1.1
, any IP address within
192.168.1.1
to
192.168.1.254
is good to connect
the Wireless LAN Access Point.
Don’t use 192.168.1.200
IP Subnet Mask:
255.255.255.0
8. Click
OK
to complete the IP parameters setting.
For OS of Microsoft Windows Vista / 7:
1. Click the
Start
button and select
Settings
, then click
Control Panel
. The
Control Panel
window will
appear.
2. Move mouse and double-click the right button on
Network Connections
item. The
Network
Connections
window will appear. Double click
Local Area Connection
icon, then User Account
Control window shown. Right click Continue button to set properties.
3. In
Local Area Connection Properties
window, Choose
Networking
tab, move mouse and click
Internet Protocol Version 4 (TCP/IPv4)
, then click
Properties
button.
4. Move mouse and click
General
tab, Select
Specify an IP address
and type in values as following
example.
IP Address:
192.168.1.1
,
,
any IP address within
192.168.1.1
to
192.168.1.254
is good to connect
the Wireless LAN Access Point.
Don’t use 192.168.1.200
IP Subnet Mask:
255.255.255.0
5. Click
OK
to complete the IP parameters setting.
Summary of Contents for LP-7316K
