11
After starting the
Cryo-Gate
the display shows the main screen (Fig. 1).
First line
from left to right:
– Button ANALOG: shows the adjusted mode and the voltage. - See point 4.4.2
– Button DMX: shows whether DMX is active and the adjusted DMX-address. - See
point 4.4.3
– Button ETH: shows the selected Ethernet protocol and whether the machine is con-
trolled via Ethernet. - See point 4.4.4
Second line
: shows the current value of how much CO
2
has already been used. This
value can be reset by pressing
RESET
, for example if a new tank has been connected.
This value is only roughly measured and does not show the exact usage.
Third line
: Actual values for fog (pump), air and CO
2
. The values can be adjusted after
pressing
MODIFY
. - See point 4.4.1
More air => higher output speed, higher fog level/carpet
More fog (thus more output/higher pump level) => more low fog - more CO
2
is needed.
Fourth line
: Adjusting a Preset. - See point 4.4.1
Fifth line
:
SETTINGS
=> change to Settings 1,
START
=> manual start of the fogging
process.
Fig. 1 Main screen
Fig. 2 Settings 1
Fig. 3 Settings 2
4. Operating the Cryo-Gate
Summary of Contents for Cryo-Gate
Page 23: ...23...
Page 24: ...24 a Look Solutions product...
