10
5.3 Switching the device off
a. Press the Mode-button [14] til “OFF” appears on the display. After 15 seconds
the machines switches into the post-run-mode automatically.
You can also switch the machine into the post-run-mode within these 15 seconds
by pressing the Enter-button [16].
The fan increases to the maximum output to dry the cooling chamber and
switch off automatically after three minutes. During this time lines appear on
the LED display [18] which move from the upper left edge down to the lower
right edge.
Then a little red point in the lower right edge of the display appears to show
that a voltage is present.
b. When you switch off the DMX signal, the machine will be switched into the
post-run-mode automatically after 15 seconds.
Note
:
Please make sure that the
Cryo-Fog
is not disconnected too early to allow the
fan to run until the cooling chamber is dry.
.
5. Operating the Cryo-Fog
_
_ _
f. After a warm up time of approx. seven minutes the machine is ready to start.
The green Ready-Led [20] blinks when the working temperature is reached. As
soon as the final temperature is reached, the LED illumates permanently.
The machine is now ready to use. For adjustments please see chapter 5.5.
