78
steering wheel now, and inspect whether the
loader can turn left or right.
NOTE: When carrying out gear-shifting operation, release the accelerator pedal
firstly and then operate the gear shifting joystick for realizing the gear shifting,
so as to protect the gear-shifting clutch.
5. Inspect the performance of service brake. On a flat and open ground, drive the loader
with forward gear 1 or forward gear 2 engaged, release the accelerator pedal, and at
the same time smoothly push down brake pedal. The loader shall slow down
obviously and then stop.
NOTE: If you cannot feel that the loader slows down obviously after the brake
pedal is stepped down, please immediately pull up the parking brake for
emergency braking. At the same time, by operating the working device joystick,
lower the boom to the lowest position, tilt forwards the bucket, and insert the
bucket tooth or blade into or push it against the ground so as to stop the loader
and ensure the safety.
6. In case there is a corner ahead, please
operate the loader in accordance with the
local laws and regulations relating to traffic.
When the loader is about to turn, pull or push
the turn lamp handle in the corresponding
direction. As indicated in the figure, push
forwards the handle if the loader will turn left,
and pull backwards the handle if the loader
will turn right. Now the front/rear turn lamps
on one side of the loader and the
corresponding turn indicating lamp on the
instrument board will come on, so as to warn
the loaders and persons around the loader
that this loader is about to turn.
The loader is equipped with a fully hydraulic steering device. The turning angle of the
steering wheel is not equal to the steering angle of the loader. When the steering wheel is
turned continuously, the steering angle of the loader will increase until the desired steering
