77
the hydraulic oil overflow. In this way, the temperature of hydraulic oil will increase
rapidly.
16.
If there is no obstacle around the loader, please turn the steering wheel slowly, and
observe whether the loader turns.
4.3.3 TRAVELLING OF LOADER
1. Operate the working device joystick to turn
the bucket backwards to the limit state; raise
the boom to the transportation position,
namely the position where the lower
articulated point of the boom is 50~60mm
above the ground.
2. Step down the service brake pedal, put down
the manual brake control handle, release the
parking brake, slowly release the service
brake pedal and observe whether the loader
moves.
The figure indicates the parking brake switch
which is pressed down.
WARNING: If the loader moves, immediately step down the service brake pedal
and pull up the parking brake. Then, inspect loader’s variable speed control
system for any failure. If the loader is on a slope, be sure to block up all wheels
with chocks so as to prevent the loader from moving, and then operate the
loader.
3. Push the gear shifting joystick so as to get the
Forward Gear I/II engaged or pull the gear
shifting joystick backwards so as to get the
Reverse Gear engaged, and at the same time
step
down
the
accelerator
pedal
appropriately. In this way, the loader will travel
forwards or backwards.
4. Inspect the engagement of each gear. Drive
the loader to a flat and open ground, get each
gear engaged respectively, and inspect the
gear-shifting operation. If in the operation of
the previous phase, the inspection on
steering performance was not carried out
owing to the small place, please turn the
