52
or near them, it will produce combustible vapors and sparks that have risk of ignition.
Thus, it is necessary to avoid welding in such a place.
If the welding sparks flying directly onto rubber hoses, wires or pipes with pressure,
these tubes may suddenly rupture and wire insulation skin may be damaged, so it is
necessary to cover these things with fire flapper.
Wear protective clothing during welding operation.
Keep the welding work site well ventilated.
Clean
all flammable materials before welding, and equip with fire extinguishers on the working site.
1.8.15 PRECAUTIONS FOR BATTERY MAINTENANCE
The negative pole (-) of the battery must be disconnected when the electrical system is
repaired or electric welding operation is performed on the machine, so as to prevent
current flow.
1.8.16 TREATMENT OF ABNORMAL STATUS
If any abnormal status is found during overhaul, repair it. Especially that when the
machine is in operation, there is any irregularity in braking system, steering system or
working device system, which can lead to serious accidents.
Please consult the designated dealer of LONKING Holdings Limited for repair according
to the fault types.
1.8.17 FILL OF FUEL OR LUBRICATING OIL
Fuel, lubricating oil, hydraulic oil, antifreeze,
brake fluid, window glass detergent can be
ignited by flame. Therefore please comply with
the following provisions:
When filling fuel or lubricating oil, close engine
No smoking.
Overflowed fuel, lubricating oil, hydraulic oil,
antifreeze, and brake fluid or window glass
detergent should be cleaned up immediately.
All top caps of container of the fuel, lubricating oil,
hydraulic oil, antifreeze, braking fluid and window
glass detergent should be tightened firmly.
Place of filling or storing of fuel, lubricating oil,
hydraulic oil, antifreeze, brake fluid or window
glass detergent should be well-ventilate.
