RCT150
19
Version:
1.0
Please follow the instructions below to change memory on RCT150.
1.
Make sure that the terminal and all other peripherals which are connected to the terminal
have been powered down and unplugged.
2. Disconnect all power cords and cables.
3. Locate the SO-DIMM socket on the system board.
4.
Push down the module until the clips at each end of the socket lock into position. You will
hear a distinctive click, indicating the module is correctly locked into position
2.2.3 Mini-PCI-E ,m-SATA SSD
Step 1: Please position the terminal as shown below
on a working table with “soft protective pad”.
Clip
Clip
Step 2: Please remove the circled five
screws.
Step 3: Mini PCI-E Connecter can then be found where circled.
