RCT150
16
Version:
1.0
2. Hardware setup
Getting Started
This section describes how to install or to replace accessories and component on your RCT150.
2.1 Pre-installation notice
Before you start installing RCT150 terminal, please read the following notices carefully.
1. Do not plug in or unplug any interior devices, such as memory module when the system
power is still on.
2. For installation and compatibility, DDR3 RAM Module provided by the manufacturer is
strongly recommended.
3. The USB device connector is Hot Swap. Do not plug in or unplug any connectors other than
USB devices when the power is still on.
4.
Do not insert or remove any devices or components from RCT150 while the power is still on.
5.
Please make sure that flat touch screen will be well protected by soft pad on working table.
When positioning RCT150 with display facing downwards.
2.2 Hardware assembly
Please make sure that the system power is turned off and the power supply is disconnected
when making any hardware changes to RCT150.
2.2.1 HDD / SSD
Step 2: Please
remove the HDD or SSD
screw.
Step 1: Please position the terminal as
shown below on a working table with
“soft protective pad”.
