Longshine LCS-8131G3, User Manual

Page: 18 / 27

802.11g USB 2.0 WLAN Dongle User Manual
17
Chapter 5. How to use the WLAN Utility(Access Point)
5.1 Introduction
To set your 802.11g USB 2.0 WLAN dongle as an Access Point(AP) , reference
In Access Point mode , your 802.11g USB 2.0 WLAN dongle as an AP . this allows you to set
up your wireless network without using a dedicate AP device. Up to 16 wireless station can
associate to 802.11g USB 2.0 WLAN dongle.
5.1.1 Additional Setup Requirement
To bridge wireless and wired using the 802.11g USB 2.0 WLAN dongle, The following
requirement must be met.
1. The 802.11g USB 2.0WLAN dongle must be installed a computer connect to the wired
network.
2. Either configure network sharing or bridge the two interfaces(Wireless & Wired) on the
computer.
3. Set the wireless station’s IP address to be in the same subnet as the computer in which
802.11g WLAN dongle is installed.
5.2 The 802.11g WLAN dongle Utility Screen
5.2.1 Select “ACCESS POINT” in the MODE field to display the screen as shown.
ACCESS POINT Mode
5.2.2 click “More Setting…”in the 802.11g USB 2.0 WLAN dongle screen to display the
screen as shown.