■ FRONT PANEL
1
Power Switch
When it is turned on, the cooling fan and all of electrical circuit
inside the machine will be operated.
2
Crater Selection Switch
It choose the Crater OFF or Crater ON.
3
Welding mode selection Switch
- Above : Checking the flow of the gas.
- Center : CO
2
/MAG welding
- Bottom : Gouging
4
Crater Current Volume
Adjust the crater current
5
Crater Voltage Volume
Adjust the crater voltage
6
Power Lamp
It indicates that the machine is on and input voltage is within
acceptable range.
7
Warning Lamp
It indicates the thermal over load or output disabled by any
electrical problems or the failure of program. When it is on, the
machine will not supply power at the output.
8
Motor Fuse (15A)
It will be broken by motor problem of wire feeder
9
Control Fuse (5A)
It will be broken by any electrical problems
10
Ammeter
Indicate the welding current
11
Voltmeter
Indicate the welding voltage