Long Range Systems
6 T9560 EZ User Manual
a. While the pager is programmed, the red LED on the transmitter
will blink one additional time for each group to program.
b. The pager will beep an additional time for each group
programmed. (
Example:
If 3 groups are set, the red LED will
blink 6 times on the T9560, and the pager will beep 6 times.)
4) Turn OFF Group Paging, press PROG-9-9-0-Enter
5) Repeat Steps 1-4 for each Group to be setup (be sure to turn
Group Paging ON for each Group and then OFF after each
Group is setup and individual pagers are programmed for that
Group)
6) When all Groups are setup and programmed, be sure that
Group Paging is turned OFF
To Page a group, press the 3 digit group number.
Example:
To Page Group
2, press PGR-0-0-2-Enter.
System ID
To change the system ID, press PROG-9-0-x-ENTER (x = sys ID from 0 to 49)
Range Test
The Range Test feature is used to broadcast a continuous signal. This will
allow for testing within your
location regarding range for your pagers to receive a page from the T9560.
To turn ON the Range Test, press PROG-9-9-2-ENTER or PGR-9-9-2-ENTER When
the range test is active, the LCD will display an 8 moving across screen. Then the red
LED will transmit once every 10 seconds. To turn OFF the Range Test, press CLEAR