(1)
Plasma Torch Euro/ Central Connector.
(2)
Earth Lead Connection Socket.
(3)
Cutting Current Control Knob.
(4)
Power Indicator: Lights when input power connected and machine
switched on.
(5)
Alarm Indicator. *
(6)
Torch System Error Indicator. *
(7)
Cutting Power Indicator: Lights when cutting power circuit activated .
(8)
Air Control Run/Set Switch. *
(9)
Air Filter Condensate Drain Tube.
(10)
Air Pressure Regulator Outlet Pressure Gauge.
(11)
Compressed Air Inlet.
(12)
Air Pressure Regulator Knob.
(13)
Mains Cable: Connected to the appreciate power supply.
(14)
Power Switch: Turn on or off the power source.
(15)
Air Condensate Filter/Trap Bowl.
*Denotes more detailed explanation of function to follow.
Further Controls Explained
Alarm Indicator (5)
Lights when over voltage, over current or electrical overheating (due to
exceeding duty cycle) is detected and protection is activated. When protection is
activated, welding output will be disabled until the safety system senses the
overload has reduced sufficiently and indicator lamp goes out. May also trigger
if machine experiences an internal power circuit failure.
Torch System Error Indicator (6
)
Lights when issue with torch system or air supply detected and cutting output is
disabled as a result. Flashing light means that torch shield cap is not installed.
Continuous light means likely damaged or missing torch consumables or insufficient
air pressure supply to the torch.
4
6
5
7
3
8
