Logosol BIG MILL, User Manual

Page: 11 / 32

11
THE WORK SITE
Prepare a work site on clean and level ground. The
easiest way is, if you place the project log across two
parallel, smooth and level blocks or logs. These log
beds should not be more than 50 cm in height.
If you are going to use logs as log beds, you
have to prevent them from rolling sideways by
using wedges, e.g.
Ensure that you do not saw on an upward slope. It
is better that the log bed is somewhat higher on the
side you start sawing on, so that you saw slightly
downwards.
Wedges, or the like, should be fixed to the log
bed on both sides of the log. This is to prevent the
log from slipping sideways when you are sawing
through it, but also to prevent the log from rolling
down on you.
Risk of serious injury.
If you are working close to a pile of logs,
secure the pile with a strong strap around the
front logs, to prevent the log pile from falling
down over you.
Keep the work site free of tools, pieces of
wood, sawdust, and other things you can trip
over.
Risk of crush injury if the log rolls down.
Always prevent the log from rolling down from
the log bed by using wedges or the like.
Tipping risk. Always check that the log is firmly
secured.
Use screws that are suitable for the purpose
when securing the log.
Do not start the chainsaw until you have read
and understood the chainsaw manual and its
safety instructions.
Always perform the ”Safety check before
starting the chainsaw” (see Safety Instructions
on p.10) before each saw cut.
PREPARING FOR SAWING
It is good if the project logs are cut straight at the
ends. In the beginning, it is a good idea if you mark
where the cuts are to be made at the root and top
end of the log. Start from the centre of the log
when you are measuring. Use a 6 mm felt tip, so the
line will match the kerf.
OPERATING INSTRUCTIONS