Logitech Electronics 200 MKII Series, User Manual, Page: 3 / 14

Specification
Display 4 decade 7-segment high brightness red LED, 14mm high
Decimal point Programmable via display board
Scaling Programmable via display board, retained in non-volatile memory.
Signal inputs
Standard (Count Up and Count Down)
Standard sensitivity 180mV to 10V- protected to 100V
Frequency Mode 0—100kHz maximum
Impedance 15k Ω minimum
Optional
High sensitivity version 12mV to 1V — protected to 100V
Analogue input module (specified as 0–1V, 0–5V, 0–10V, 0–20mA, 4–20mA)
Control inputs Stop (SP) and Reset (RS)
Opto-isolated — require sink to 0V of 220 Ω maximum)
Outputs
Standard Transducer supply 10V DC nominal unregulated @ 80mA max
Optional Higher transducer supply voltage 24V DC @ 50mA max
Connections Screw terminals on rear panel.
Power requirement
AC Factory set to 115V or 230V AC 50/60 Hz, loading 3VA.
DC Mains Counters can also be powered by providing 10V to 15V DC @
250mA max via the 10V terminal. Alternatively, if specified at time of
order, they can be configured to operate from 24V DC only (refer to DC
Supplies on page 6).
Temperature range
Operating 0°C to +50°C
Storage -20°C to +80°C
Dimensions 96 x 48 x 110mm (panel cut-out 92 x 43mm).
Weight 400g (standard mains supply version)
200C-
MKII
_hb v3.1 01/2020 ! 3