GB
41
Spray Arms
Food particles can get stuck in the spray arm jets
and bearings. The spray arms should be checked and
cleaned regularly:
1. Ensure the dishwasher is switched off.
2. To remove the upper spray arm, hold the nut, turn
the arm clockwise to remove.
3. To remove the lower spray arm, remove the lower
basket, then pull the spray arm upwards.
4. Wash the arms in warm soapy water, and use a soft
brush to clean the jets. Rinse thoroughly.
5. Replace the arms securely.
Internal Care
Filtering System
The filtering system in the base of the wash cabinet retains coarse debris from the washing
cycle. The collected coarse debris may cause the filters to clog. Check the condition of the filters
regularly and clean them if necessary under running water.
Follow the steps below to clean the filters in the wash cabinet.
1. Ensure the dishwasher is switched off.
2. Turn the coarse filter anti-clockwise and gently lift it out.
3. Rinse all the filters under running water, including the filter cylinder, and then refit all filters
in the reverse order.
4. Gently rescrew the coarse filter in clockwise direction. There will be a slight click when
located correctly.
t
Do not over tighten the filters. Put the filters back in sequence securely, otherwise coarse
debris could get into the system and cause a blockage.
t
NEVER
use the dishwasher without filters in place. Improper replacement of the filter may
reduce the performance level of the appliance and damage dishes and utensils.
LID60W16N_IB_5L_RC_160817_grace.indb 41
17/8/16 12:00 pm