![background image](http://html1.mh-extra.com/html/logik/lghobx12/lghobx12_instruction-and-installation-manual_1935149017.webp)
17
* All images are for indication only; please refer to your individual unit for actual item.
Cut Out Dimensions
The dimensions of the cut-out are given in the diagram.
Width: 560mm Depth: 490mm
Check the Hob After Installation & Before Using
When the hob has been fully installed it will be necessary to check the minimum flame setting. To do this, follow
the step below,
• Turn the gas tap to the MAX position and ignite
• Set the gas tap to the MIN flame position then turn the control from MIN to MAX several times.
If the flame is unstable or is extinguished follow the procedure below.
Pressure Testing
1. Remove the left hand pan support and front left burner cap and crown.
2. Fit manometer tube over the injector.
3. Turn on the burner gas supply and ignite all the other burners.
4. Turn off the burner supplies.
490
mm
560
mm
All measurements given in millimetres (mm)
and cutout dimensions are given as: ‘nominal
measurement’
Product Overall Dimensions
Width: 580mm Depth: 510mm
Fitting the Hob into the Worktop
• Apply the adhesive sealing material “C” all the way round the aperture on the worktop to match the outer
perimeter edge of the appliance. Ensure that the junctions overlap at the corners and no gap is left along the
sealing material.
• Insert the appliance into the aperture and fix in position using the brackets and screws. Adjust the position of
the brackets depending on the thickness of the worktop as indicated below and
tighten the screws evenly.
T
C
C
Worktop
t<25mm
t>25mm
t
t
Hob
A
A
B
B
• Carefully trim away the excess sealing material “C” from around the appliance.
• If the appliance is to be installed above a cupboard or drawer it is absolutely essential that you
place a separating board between the base of the appliance and the drawer unit.
• This must be fixed in place 60 mm below the hob to prevent accidental contact with the bottom of
the hob which may be hot.
LGHOBX12_IB_120601_Annie(Check).indd 17
12年6月1日 下午5:14