36
GB
Starting a Wash Cycle
1. Ensure the unit is connected to the mains power and the water supply is fully opened (water pressure
between 0.04MPa and 1.00MPa).
2. Open the door. Pull out the lower and upper baskets, load the dishes and push the baskets back. It is
recommended that the lower basket is loaded first, and then the upper basket.
3. Pour in the detergent or place the detergent tablet in the detergent compartment and close firmly
afterwards.
4. Close the dishwasher door. A click sound should be heard when the door is closed correctly. Do not
slam the door.
5. Press the Power button, the power indicator light will illuminate.
6. Select the wash cycle programme based on the loading and soil requirements. Please refer to the
section Wash Cycle Table.
7. The indicator light of the selected programme will illuminate.
8. The washing cycle will begin shortly.
9. The display window shows the state of the dishwasher.
a. “--:--” means the unit is on stand by mode.
b. “H:MM” and not flashing means the unit is on pause.
c. “H:MM” and flashing means the unit is running.
Changing a Programme
To change the programme if the washing cycle has already started, follow the steps below.
1. Open the door slightly to avoid water spillage before opening the door fully. Check if the unit has
dispensed the detergent or detergent tablet. This will depend on how long the washing cycle was
running for.
2. If the detergent dispenser lid is opened, we suggest you to allow the wash cycle to complete.
3. If the detergent dispenser lid is still closed, close the dishwasher door, press and hold down the
program button for 3 seconds to cancel the programme. You can then select the required new
programme button. The unit will start the new washing cycle shortly.
OR
Press the required new programme button for more than 3 seconds to change the running
programme. The unit will start the new washing cycle shortly.
At the End of a Programme
At the end of the programme, the dishwasher will beep.
If you open the dishwasher’s door during the washing cycle and then close it, the dishwasher
will continue the current washing programme after 10 seconds. However, if the door is not
closed correctly after 1 minute, the dishwasher will beep at 1 minute intervals.
The condensation strip helps prevent the risk of steam damage to the worktop edging above
the dishwasher. It is advisable to leave the door closed until you are ready to unload the
crockery. Do not leave the door only partially open. Do not leave the appliance unattended with
the door fully open as this could present a trip hazard.
LDW45W15N_IB_5L_Final150223.indb 36
23/2/15 4:55 pm
