Logik L612WM11, Installation Manual And Instruction Manual

Page: 6 / 28

Moving and Installing
Removing the Transit Bolts
Four transit bolts keep the interior of the washing machine in place while it’s being moved.
They need to be removed before installation. Use a spanner (not supplied) and follow the instructions
detailed below.
Moving the Washing Machine from One Location to Another
Before you move the washing machine:
• Shut off the tap and run the washing machine to drain the water. Drain any remaining water from
the pump hose.
• Disconnect the mains cable.
• Attach the transit bolts.
To remove the transit bolts:
1. Use a spanner to loosen the four bolts. They are located at the rear side of the washing machine.
2. Pull the bolts out horizontally. Make sure the entire bolt is removed.
3. Push the four cover caps (included with your accessories) into the respective bolt holes.
Don’t run the washing machine without removing the transit bolts, as this can cause
excessive vibrations.
You’ll need the transit bolts again if you move the washing machine, so make sure you keep
them in a safe place.
1 2 3
Make sure to fix the transit bolts prior to moving the washing machine.
INSTALLATION
6
L612WM11_IB_final110406_running change.indd 6 06/04/2011 6:12 PM