LOGICOM CALIS, Manual, Page: 16 / 28

31 30
ON : light activated
OFF : light deactivated
• Press
(7)
to validate the setting.
• Press and hold key (9) for 2 seconds to r estore standby mode.
N.B. : During this operation, the handset automatically r eturns to standby when no button has
been pressed for 60 seconds.
2-26 Enabling/disabling the handset out-of-range alar m
When this function is activated, the handset beeps during calls to indicate that the hand -
set is too far away from its base.
T o enable or disable this function, follow the steps below :
• The handset is on standby (no call tone).
• Press key
(7)
• “ PHONE BOOK ” is displayed on the LCD scr een.
• Press key (
6)
to select “
HANDSET
”
• Press key (7)
• “ BEEP ” is displayed on the LCD scr een.
• Press key
(7)
• “ KEY ” is displayed on the LCD scr een.
• Use key (
6)
until “
OUT -OF-RANGE
” is displayed
• Press key (7)
The cur rent setting is displayed (ON or OFF) :
• Press key (5) or ( 6) to enable or disable the signal for indicating the hand -
set is out of range.
ON : light activated
OFF : light deactivated
• Press key (7) to validate the setting.
• Press and hold key (9) for 2 seconds to r estore standby mode.
N.B. : During this operation, the handset automatically r eturns to standby when no button has
been pressed for 60 seconds.
C
OK
OK
OK
OK
OK
C
OK
30
• Press key (7)
The cur rent setting is displayed (ON or OFF)
• Press key (5) or ( 6) to enable or disable the key sounds.
ON : key sounds enabled
MUTE: key sounds disabled
• Press (7) to validate the setting.
• Press and hold key (9) for 2 seconds to r estore standby mode.
N.B. :
During this operation, the handset automatically r eturns to standby when no button has
been pressed for 60 seconds.
2-25 Enabling/disabling the low batter y alarm
When this function is activated, the handset issues a sound signal to indicate that the
batteries are flat, during a call.
To enable or disable this function, follow the steps below :
• The handset is on standby (no call tone).
• Press key (7)
• “ PHONE BOOK ” is displayed on the LCD scr een.
• Press key ( 6) to select “ HANDSET ”
• Press key
(7)
• “ BEEP ” is displayed on the LCD scr een.
• Press key (7)
• “ KEY ” is displayed on the LCD scr een.
• Use key (
6)
until “
LOW BA TT
” is displayed on-scr een.
• Press key (7)
The cur rent setting is displayed (ON or OFF) :
• Press key (5) or ( 6) to enable or disable the low batter y alarm.
OK
OK
OK
OK
C
OK
OK