14
FreedomAlert
®
v0.2
Adding Additional Pendants to the System.
FreedomAlert comes with one Pendant. If you want to add additional pen-
dants to your system - follow the directions here. If not, skip this section.
The Pendant’s unique ID code should already be learned into the Base unit
when it came from the factory. You can add additional Pendants (up to 16)
to the system by simply teaching each pendant’s ID code to the Base unit.
To program a new Pendant to the Base unit:
On the Base Unit
:
1. Push and release the RED Code Learn button on the back of the base
unit. You will hear a voice prompt “Synchronizing Mode”
On the Pendant:
2. PUSH the Gray Battery Test button and then IMMEDIATELY push the
Blue Panic button –HOLD both buttons until you hear “Synchronizing
Mode” from the pendant - then release both buttons on the pendant.
• If “Base and Pendant out of Range” is heard from the pendant, STOP
- wait 30 seconds and start at step #1 again.
3. When Synchronizing has been successful you will hear “All Systems
are OK” and then it will announce the call setting that the base is set
to – Friends 911 Mode, Friends Only or 911 Only.
• If “Base and Pendant out of Range” is heard from the Base or Pen
-
dant, STOP - wait 30 seconds and start at step #1 again.
Notes:
• You have less than 10 seconds after pushing the RED Code Learn button
on the base unit to get the pendant to enter “Synchronizing Mode”.
• Teaching additional pendants does not erase previously learned pen-
dants.
• The base unit will automatically exit the pendant learning mode after
about ten seconds.
• If you hear the voice prompt “Base and Pendant Out of Range” an error
has occurred, wait 30 seconds for the base to reset and repeat steps 1
& 2.
