4
Emergency Wall Communicator
v5.2
Notes:
• You have up to 45 seconds after pushing the RED Code Learn button
on the Base unit to get the EWC to enter “Pendant Learning”.
• Learning additional Pendants or EWCs does not erase previously
learned Pendants or EWCs.
• The Base unit will automatically exit the Pendant learning mode after
several seconds or if Pendant learning failed.
• Only a combined total of 9 Pendants and EWCs (up to 5 two-way
pendants and/or EWCs and 4 waterproof pendants) can be learned
to a Base unit. If a Pendant has been lost or replaced, erase all the
Pendants and relearn all current Pendants and EWCs. (See next
paragraph).
At a later point in time, you might want to erase your previously learned
pendants. You can erase all previously learned Pendants and/or EWCs by
simply holding down the red
Code Learn
button at the back of the Base
unit for 8-10 seconds. You will hear the confirmation of “Previous Pendant
Codes Erased” from the Base unit. After that, you can program a new
Pendant to the Base unit following the steps above as desired.
Mounting the Product.
You have two choices to mount the product to the wall. You can use the
screws provided - or you can use the special Velcro style fastener provided.
If using the screws - Attach the mounting plate to the wall. If using the
Velcro - make sure the surfaces are clean and dry before mounting.
Battery Check:
The 4 AAA alkaline batteries should power the unit for about nine months
in standby mode. When the EWC is used - there are several hours of talk
time on fresh batteries. We recommend replacement of the batteries every
6 months, just like a smoke detector.
The EWC has a built-in battery tester to allow you easy confirmation of the
status of the batteries. When you press the small Gray button on the EWC,
a voice announcement will inform you of the condition of the battery. One
of the following messages will be heard: