v5.2
Emergency Wall Communicator
3
Installing the Battery
Slide the battery cover to the left to unlatch the cover
Install the 4 AAA alkaline batteries - noting the polarity on the inside of the
battery cover. The spring contacts are meant to touch the negative side of
the batteries. Close the battery cover and latch to lock cover.
Learning the EWC to the Base unit of Your PERS System.
Note: Throughout this manual, EWC will refer to the Emergency Wall
Communicator; Pendant will refer to a hand-held pendant used by the
Personal Emergency Response System (PERS) and Base will refer to the
base unit of the PERS system.
On the Base Unit:
1. Push the RED Code Learn button on the back of the Base unit for 2
seconds, then release. (Use the tip of the screwdriver or a ball-point
pen to reach through the case). You will hear a beep and then voice
prompt, “Pendant Learning.”
On the EWC:
2. PUSH and hold the RED Help button and also the GRAY Test button
simultaneously –HOLD both buttons for a few seconds until you
hear “Pendant Learning” from the EWC - then release both buttons.
• If “Base and Pendant out of Range” is heard from the EWC, stop
- wait 30 seconds and start at step #1 again.
3. When Pendant learning has been successful you will hear “Pendant
Code Learned” and then it will announce the mode of the Base unit.