DMD660 - OPERATING MANUAL // PAGE 6
2 SAFETY
2.1 TARGET AUDIENCE
This Operating Manual is intended for Skilled Persons only. Refer to
Chapter 2.8 Skilled Persons on page 9 to
ensure that personnel meet all requirements.
2.2 GENERAL SAFETY REGULATIONS
In general, the following safety regulations and obligations apply when handling the product:
• Do not operate the product unless it is in a clean and perfect condition
• Do not remove, change, bridge, or bypass any protection, safety, or monitoring equipment
• Do not convert or modify any components without written approval from LOGICDATA
• In the event of malfunction or damage, faulty components must be replaced immediately
• Unauthorized repairs are prohibited
• Do not attempt to replace hardware unless the product is in a de-energized state
• Only Skilled Persons are allowed to work on the DMD660
• Ensure that national worker protection conditions and national safety and accident prevention
regulations are observed during operation of the system
2.3 INTENDED USE
The DMD660 is a Spindle Actuator for electrically Height-Adjustable Tables. It is installed by Resellers in a
Height-Adjustable Column for electrically Height-Adjustable Tables. It is controlled by an integrated Control
Unit. It is intended for indoor use only. The system may only be installed in compatible Height-Adjustable
Tables and with LOGICDATA-approved accessories. Contact LOGICDATA for further details. Use beyond or
outside the intended use will void the product’s warranty. Please refer to the Operating Manual of each prod-
uct in the DM System to determine its individual intended use.
2.4 REASONABLY FORESEEABLE MISUSE
Usage outside of the intended use for each product may lead to minor injury, serious injury, or even death.
Reasonably foreseeable misuse of the system includes, but does not extend to:
• Using the system as a climbing or lifting aid for people or animals
• Connecting unauthorized parts to the product. If you are unsure as to whether a part can be used
with the DMD660, contact LOGICDATA for further information
• Overloading the Table System (see below)
NOTICE
Load limits are defined as follows:
• Maxiumum Static Force:
1200 N
• Maximum Pull Force on the Actuator:
150 N
Permissible loads refer only to the DMD660. They do not account for additional loads.
Resellers must include information about maximum permissable loads in the docu-
mentation for their final product.
