Extrovert 4G LTE Modem for EMEA/NA
NWK200
Connecting to modem via PuTTY (Windows)
•
In the Device Manager, find out which virtual COM the modem is attached to.
•
Open the ‘Modems’ category flyout,
• Right click the Sierra modem entry
• Select properties. The port number [n] is listed at the top of main page.
• Open PuTTY
• Select the Serial radio button in the main window.
• In the <<connection>> box, replace COM1 with the COM[n] from the modem properties.
• Set the baud rate to 115200.
• Click Open.
• Make the modem “echo” back the commandes. In the terminal window, type
• ATE1 and press Enter. It is possible that no text will be displayed until the command is executed.
• If Windows 7 is installed, change USB communication mode from QMI to MBIM with the following commands
• AT!ENTERCND=”passwd” <--where
passwd
is replace with actual password
• AT!USBCOMP=1,1,100D
• User can now send any AT commands necessary
Connecting to modem via minicom (Ubuntu)
• From Ubuntu terminal
•
sudo minicom -s
• Serial port setup
• Press a - change name to ‘/dev/ttyUSB2’
•
Press g to change software flow control to YES
• Exit (this will drop you to a new shell)
• Make the modem “echo” back the commandes. In the terminal window, type
•
ATE1
• User can now send any AT commands necessary
Configuring Access Point Name (APN)
Users should use the carrier specific firmware when available. If not available, users using the Generic firmware may have to configure
their carrier’s APN before the modem will connect. Most carriers publish a FAQ for APN settings.
Configure the APN using Skylight
Windows users can download and install Skylight Connection Manager from Sierra Wireless for better connection management.
Skylight is not available for other operating systems.
Connecting to the modem
Technical Functions
US Office
Phone: +1 802 861 2300
Email: [email protected]
www.logicsupply.com
EU Office
Phone: +31 088 5200 700
Email: [email protected]
www.logicsupply.com
13
