Logic Group MATRIX ZBA Series, Installation Manual And User'S Manual, Page: 28 / 31

MATRIX ZBA7140 User’s manual EN
Logic Group A/S
Page 28 / 31
Parameter 15, Parameter size 4. Switch Multilevel Set double-activation values for pushbutton 3.
This parameter specifies the value that are sent to the devices in the Switch Multilevel association group (group 7)
when the pushbutton is double-pressed.
Value Description
Byte 1: Enable / Disable
0
Disabled – A double activation of the pushbutton will not send commands to devices in the
association group.
1
Enabled – A double activation will send commands to devices in the association group. Devices
will receive commands with the values set in 3 following bytes. (Default)
Byte 2: Upper switch value
0 – 99,
255
When double pressing the pushbutton for ON, a Switch Multilevel Set with this value will be send
to devices in the association group. (Default = 99)
Byte 3: Lower switch value
0 - 99
When double pressing the pushbutton for OFF, a Switch Multilevel Set with this value will be send
to devices in the association group. (Default = 0)
Byte 4: Duration
0 - 255
When double pressing the pushbutton the Switch Multilevel Set with this duration value will be
send to devices in the association group.
0
: Use dimmer default timer value. (Default)
1 – 127 : Duration in seconds.
128 – 255 : Duration in minutes (minus 127) from 1 – 128 minutes, where 128 is 1 minute.