background image

Playing Sounds, Words or Phrases

The device can only play one tag at a time. It is important you check that no two tags with the same ID 
number are used on a single device (the ID number is located on the back of tag)
1.  select the Sound Tag you want to use.
2.  place a Sound Tag on or over the target area depending on the mode you have chosen.
3.  TOUCH requires a press, PROXIMITY needs just that, a swipe or a hover over the target area. 
Remember you can record as much as 8 seconds on any one tag.

Changing Speaker Volume

The device has four volume levels. You can increase or decrease the volume any time you like. 
To increase the speaker volume, press the INCREASE VOLUME Programming Tag.
To decrease the speaker volume, press the DECREASE VOLUME Programming Tag. 
After each press the device will play a test tone.

Page5

Logan® ProxPAD™ Instruction Manual revision 1.0 

FCC Notice

Note: This device complies with part 15 of the FCC Rules. Operation is subject to the following two 
conditions: (1) This device may not cause harmful interference, and (2) this device must accept any 
interference received, including interference that may cause undesired operation.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, 
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against 
harmful interference in a residential installation. This equipment generates, uses and can radiate radio 
frequency energy and, if not installed and used in accordance with the instructions, may cause harmful 
interference to radio communications. However, there is no guarantee that interference will not occur in
a particular installation. If this equipment does cause harmful interference to radio or television reception, 
which can be determined by turning the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
•   reorient or relocate the receiving antenna.
•   increase the separation between the equipment and receiver.
•   connect the equipment into an outlet on a circuit different from that to which
  the receiver is connected.
•   consult the dealer or an experienced radio/TV technician for help.

“Under Industry Canada regulations, this radio transmitter may only operate using an antenna of a type and maximum 
(or lesser) gain approved for the transmitter by Industry Canada. To reduce potential radio interference to other users, the 
antenna type and its gain should be so chosen that the equivalent isotropically radiated power (e.i.r.p.) is not more than that 
necessary for successful communication.”

“This device complies with Industry Canada license-exempt RSS standard(s). Operation is subject to the following two 
conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference 
that may cause undesired operation of the device.”

Conformément à la réglementation d’Industrie Canada, le présent émetteur radio peut fonctionner avec une antenne d’un 
type et d’un gain maximal (ou inférieur) approuvé pour l’émetteur par Industrie Canada. Dans le but de réduire les risques de 
brouillage radioélectrique à l’intention des autres utilisateurs, il faut choisir le type d’antenne et son gain de sorte que la

puissance isotrope rayonnée équivalente (p.i.r.e.) ne dépasse pas l’intensité nécessaire à l’établissement d’une communication 
satisfaisante.

Le présent appareil est conforme aux CNR d’Industrie Canada applicables aux appareils radio exempts de licence. 
L’exploitation est autorisée aux deux conditions suivantes : (1) l’appareil ne doit pas produire de brouillage, et (2) l’utilisateur 
de l’appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible 

FE

DE

R

A

 C

O

MM

UNIC

ATION

S  C

O

M

M

IS

SIO

N

USA

Page 8

 

Logan® ProxPAD™ Instruction Manual revision 1.0

Summary of Contents for ProxPAD







Reviews: