3
Assembly Procedure
A. Angle Pivot
1.
Turn base over and align pivot over base.
2.
Insert angle pivot bolt thru holes (Fig. 1).
3.
Tighten two screws tight (Fig. 2).
B. Angle Block
1.
Align angle block onto pivot (Fig. 3).
•
While tightening screw, rotate pivot until pivot
drags slightly.
NOTE: Amount of drag on pivot increases
accuracy of cut.
C. Base
1.
Turn saw base over and install base board. Be
sure holes for rods are located toward back of
saw base (Fig. 4).
D. Clamp Rod
1.
With rounded end facing up, set rods into holes
in base board.
2.
Align holes in rods with holes back of saw base
3.
Install screw thru base, thru spacer and thru rod.
Tighten with nut. (Fig. 5).
4.
Slide clamps onto rods.
E. Saw
1.
Slide saw onto guide rods ( Fig. 6 ).
2.
Slide down until hold up springs rest on rod tops.
F. Mounting - Optional
•
Mount base board to table using lag bolts
supplied. Drill 1/4” (6mm) pilot hole for bolts.
•
Use two 4” deep throat C-clamps. Available at
local hardware store.
Instruction Manual
Model F100-1
Studio SAW
Logan Graphic Products Inc., 1100 Brown Street, Wauconda, IL 60084 Toll Free 1 800 331 6232 www.logangraphic.com
Fig. 1
Fig. 3
Fig. 2
Fig. 4
Fig. 5
Fig. 6
✔
✔
✔
Summary of Contents for F100-1
Page 4: ......
