11
Fertilizer Spreader OM
Adjusting for High or Low Range
1
Determine if the application will be spread in high range
or low range.
High range
- the chain must be on the inside sprockets.
Low range
- the chain must be on the outside sprockets.
If adjustment is needed, loosen the conveyor drive chain
tensioner (1) and move the chain to the appropriate set
of sprockets. Reposition the drive chain tensioner and
retighten. Chain tensioner should be oriented such that it
does not touch sprockets.
IMPORTANT:
Read the application rate chart for
operating in high range. To avoid undue
stress on the conveyor mechanism, it is
recommended to use the largest practical
gate opening in low range before
changing to high range.
To assure a uniform application rate around field edges,
make a border application with these adjustments.
Reduce to 1/2 fan speed, gate opening, and travel
interval.
CAUTION:
Do not use a gate setting of
1.5 in. (3.81 cm) in high range. This could
cause undue stress on the hopper from a high
conveyor speed.
Operation
Engaging the Conveyor Ground Drive
1
2
Raise the lever (1) to the upper position as shown to
engage the ground drive. Secure with retaining pin (2).
To disengage the drive, move the lever to the lower
position and secure with the retaining pin.
During transport, always have the ground drive
disengaged.
IMPORTANT:
Be sure the chain engages the hub
sprocket properly. If it slips to one
side, raise the chain and realign before
lowering.
Summary of Contents for FS 800
