18
Battle Ax OM
Lubrication (Cont’d)
Grease Points Location (Cont’d)
1
8
Location:
Hook end rotor bearing (2).
Interval:
Every 8 hours of operation.
Maintenance
Overhung Load Adapter
The motor covers must be removed to access the
overhung load adapter. Refer to “Removing Motor
Access Covers” on page 19 for instructions.
1
2
Remove the plug from the port (1) located on the top of
the overhung load adapter, and the plug from the lower
port (2) located on the back side.
Partially tilt the Battle Ax to drain the hydraulic oil.
Reinsert the lower plug and tighten.
Using a funnel placed into the top port of the overhung
load adapter, add 4 oz. of universal hydraulic fluid.
Return the plug back into the top port and tighten.
NOTE:
If replacing bearings or seals in the overhung
load adapter, be certain to refill with hydraulic
fluid after reassembly.
Summary of Contents for Battle Ax 20 Series
