13
(fig.3)
Example 3
(fig.3)
:
Two products with inverse logic are needed to be
operated from the mini remote control. The product
should always operate, and by the pressing the
appropriate button should make the corresponding
output stop working. The voltage supply for operating
the load should be connected at the common terminal.
11 – REPLACING THE BATTERIES
CAUTION: ENSURE THAT THE EQUIPMENT’S POWER SUPPLY IS SWITCHED OFF
BEFORE REPLACING THE BATTERIES IN ORDER TO AVOID ACCIDENTAL ACTIVATION OF
THE EQUIPMENT.
CAUTION: THERE IS A RISK OF EXPLOSION IF A BATTERY IS REPLACED WITH
AN INCORRECT TYPE. DISPOSE OF THE USED BATTERIES ACCORDING TO THEIR
INSTRUCTIONS.
1.
Remove the silicon protection case from the transmitter.
2.
Use a flat screwdriver on the edge of the remote on the top and twist it in order to remove
the back part of the transmitter.
3.
Remove the battery from the electronic control card.
4.
Replace the battery with a new CR2032 battery. Ensure the polarities are correct.
5.
Replace the back part of the transmitter and GENTLY TIGHTEN THE CAP while ensuring that
the rubber seal is correctly positioned so that the product remains waterproof.
Summary of Contents for 636305
Page 17: ...17 ...
