58
Avoid using abrasive materials or any kind of sharp metal scraping tool to clean the glass
oven doors to prevent them from getting scratched or cracked.
2.4. REPLACING THE LIGHT BULB
Turn the cooker off at the mains before replacing the bulb.
Open the oven door, remove the protective glass cover, replace the light bulb (CAUTION: it
must be resistant up to 300°C) and replace the glass protection.
2.5. GLASS COVER
To assemble the cover put the hinges into the special spaces in the wall protection of the
cooker fitting into the existing slits (A), lift the cover up in vertical position (B) and push down
until the hinges go to their place (C).
To disassemble the cover make the contrary of the above-described operation.
A
B
C
3. USING THE COOKER
WARNINGS:
- If the burner flames accidentally go out, turn off the KNOB and wait for at least one minute
before igniting.
- Using a gas cooker produces heat and humidity in the room where it is installed. Ensure the
room is well ventilated by keeping all the natural air vents open or by installing an extraction
hood with flue pipe.
- Intensive or extensive use of the cooker could may require supplementary ventilation e.g.
opening a window, or more efficient ventilation e.g. increasing the capacity of the mechanic
ventilation, if installed.
-
The front control panel has one or two lights, depending on whether the oven is gas or electric.
If the cooker has a gas oven a green light will illuminate when a heated accessory is turned on
(ELECTRIC PLATES, ROTISSERIE, ELECTRIC GRILL). If the cooker has an electric oven,
there is a green light and also a yellow light, which turns on and off when the THERMOSTAT
cuts in to regulate the oven temperature.
3.1. USING THE COOKING HOB
Gas burners
Automatic electronic ignition built into the knob
: turn the knob to the maximum position
push it in and the burner lights up automatically.
•
No gas supply (knob turned off)
