电梯控制器用户手册
V2.0 V2.0 User Manual for Lift Controller
第
5
页
共
8
页
IV. Wiring diagram instruction
1. Installation
To facilitate wiring, the lift controller should be positioned near to the lift
control cabinet at the top of lift. Lift control reader, which is mounted
on the car,.Lift reader power supply is powered by the lift controller.
2. Wire requirement:
Lift card reader and lift controller: RVVP128 (4*0.5);
Lift button and lift controller: RVV (2*0.5) (button on the first floor);
24V power for lift controller: RVV (2*0.5)
12V power for lift reader: RVV (2*0.5)
3. After converting 110-240V to 24V/12V, allow the power supply connected to the main
board of lift controller.
4.Wiring diagram for lift controller and lift: Connect the wires of lift floor buttons to the
corresponding binding posts on the main board .(The floor number on floor button should
be consistent with that on the lift controller).
5. Wiring diagram for lift card reader and lift controller: Connect lift controller to lift Reader
according to the Wiring Diagram, the card reader will be constantly illuminated after
power-on.
