14
lococookers.com
TROUBLESHOOTING
PROBLEM
POSSIBLE CAUSE
SOLUTION
Burner will not light.
Bad connection between the
regulator and LP tank.
Make sure the regulator
coupling nut is fully tightened on
the LP tank valve.
The LP tank is empty.
Refill LP tank at an authorized
dealer or purchase new filled LP
tank.
Burner does not stay lit.
Excessive wind conditions.
When appliance is cool, move
appliance to different location
where high wind is not a factor.
Relight burner.
The LP tank is empty.
Refill LP tank at an authorized
dealer or purchase new filled LP
tank.
Water, grease or oil does
not reach desired cooking
temperature.
Regulator control knob is not
fully opened.
Fully open regulator control
knob by rotating it in a clockwise
direction.
Overfill Protection Device (OPD)
on LP tank has been activated/
tripped.
To reset the Overfill Protection
Device, turn the regulator
control knob and the LP tank
valve OFF. Disconnect the
regulator from the LP tank
and wait at least one minute.
Reconnect the regulator to the
LP tank and fully open LP tank
valve.
Faulty or obstructed regulator
hose.
Contact customer service for
replacement regulator/hose
assembly.
5. To clean the burner tube/venturi, first
disconnect the regulator hose from the
burner tube. Look inside the burner
tube for nests, webs or mud. To remove
obstructions, use a flexible brush or bend
a small hook on the end of a flexible wire.
When obstructions are clear the regulator
hose can be connected to the burner tube.
CARE AND MAINTENANCE
6. Confirm that all components are completely
dry before using or placing in storage.
7. It is recommended to thoroughly clean the
appliance prior to every use.
8. Store all components in a clean, dry location
when not in use.
