15
7000INST Copyright Lockmasters, Inc. 5/25/11
attach the Front Plate to the door continued
step 13B
– Move to the Inside Base Plate side of the door to
secure the lower portion of the Front Plate. Place a finishing
washer (H) on each of the (2) ¼”-20x2” flat head Phillips screws
(H) and insert into the (2) lower (B) holes. Tighten to a snug fit.
STANDOFF KIT OPTION – if the Stand-off kit is installed
use the (2) shorter ¼-20 flat head Phillips screws supplied
with the Stand-Off Kit instead of the longer (H) screws.
step 14 – remove the Inside Base Plate cover
step 14a
– Use the 3/32” T-Handle hex wrench and remove all (4) 8-32x3/8” socket
head button screws.
step 14B
– Retract the bolt by depressing and holding the exit handle.
step 14c
- With a flathead pocket screwdriver insert under the cover, behind the
handle and rotate the screwdriver. The cover will release. Tilt the cover and slide
through the handle to remove.
DOOR WARNING –
It is imperative that the door remains open during
installation of the LKM7000. If the door closes and latches while the
back cover is removed the relockers will trigger into a lock-out.
step 15 – Measure the spindle tube
step 15a
– On the inside of the door seat the
Inside Base Plate with the spindle tube going
through the A hole until flush against the door
and hold in position.
step 15B
– Move to the front side of the door and
mark the spindle tube flush with the Front Plate or
count the number of exposed grooves on the
spindle tube. Remove the Inside Base Plate in
order to remove the spindle tube.
lKM7000
Installation
13b - Move to IBP side and secure the bottom of
the Front Plate.
14a - Remove the (4) 8-32x3/8” socket head but
-
ton screws from the IBP cover.
14b - Press and hold the exit handle to retract
the bolt.
14c - Insert a flathead screwdriver under the
cover, behind the handle and rotate. The cover
will release. Tilt the cover and remove.
15b - Mark the spindle flush with the Front Plate.
14c - Take a flathead pocket screwdriver and
insert under the cover, behind the handle and
rotate.
15a- Insert IBP Spindle thru the A hole.
