9
Pass Code & Function Set up
Remark
1. We recommend to use alkaline batteries in order to stabilize the power supply.
2. Do not mix alkaline batteries with regular zinc-carbon ones or mixed brands.
3. Do not use any chemical liquid or lubricating oil with additives to clean the lock
body, it will damage the surface or mainboard.
4. If there is any problem with the product, please contact LDS.
10
The lockset will be unlocked by key or pressing the User Code on keypad from the outside or
by the interior turn-button.
The lockset will be locked by key or by pressing the Programming Button on keypad from
the outside or by the interior turn-button.
14-1 The lockset will automatically lock itself within 10~99 seconds when this function
is programmed.
14-2 This function is not preset at the beginning; it can be set if needed.
14-3 The preset delay-time is 30 seconds; you can adjust the period as you want.
14-4 Please repeat the same programming steps to cancel Auto-Locking function when
needed.
15-1 You will hear beep sounds when pressing
, programming or operating
errors. It can be turned off if needed.
15-2 LED Illumination is still functioning when it's in mute. As there will be no
warning alarm, we suggest not to mute the beeper if it's not necessary.
15-3 Motor operating sound cannot be muted.
The system will shut down if entering unauthorized codes over 5 times.
The System will be operational again after 45 sec.
The LED Keypad will light up when pressing any button for ease of operating in the
dark.
12.Unlock the
13.Lock the
14.To Activate / Deactivate Auto-Locking Function
15.Toggle Mute On/Off
16.Code Protection Function
17.Illumination
lockset
lockset
keypad
1. The Lockset must be in the unlocked position while programming.
2. Change default Programming Code (0000) and User Code (1234) before
function set up.
3. LED flashes orange slowly while programming. LED flashes green twice with 2 long
beeps when input is correct. LED flashes red 3 times with 3 beeps when incorrect.
(You need to wait for 6 seconds or press programming button
when incorrect input is entered, then the system will be operational again.)
4. Each programming step should be done within 6 seconds.
5. You can lock/unlock this product with either the key or keypad.
Please refer to the following programming table for function set up.
