Locca Sure-Touch User Guide |
9
Step 4 i)
The most common requirement is to allow the
Locca Receiver to also operate a door release that
is operated by an intercom or other system where
you press a button to release the door.
Adding the Locca Receiver allows you to use the
Locca Remote Key to release the door from outside
or around the inside of your home.
Check with the instructions or manufacturer that
the existing buttons are normally open low-voltage
switches (up to 24V).
Remove the link that is pre-installed between pin
2 and pin 3 of the connection block at the bottom
of the Receiver. Then connect pin 3 and pin 5
across (in parallel) an existing switch. You can
do this at a connection block either in the central
intercom controller or at one of the handsets.
These pins are connected by a relay when a
Locca Remote Key is operated.
Step 4
Using alternative electric door
releases
You can also use your Locca Receiver to operate
an entry-phone, intercom, keypad, electric or
magnetic door release system.
You are advised to use an electrician to ascertain
how the existing release is switched and to make
this connection.
The terminal block can be accessed by removing
the battery cover (see page 3).
Back view of Locca Receiver
Rechargeable
battery
Screws for
terminal
6 5 4 3 2 1
Intercom system
Existing button
to release door
Locca Receiver