8
| Locca Sure-Touch User Guide
Step 2
Install the electric door release
into the door frame
Run the pre-installed wire from the Locca
Receiver to the electric door release. Attach
the wire to the door release. If the pre-installed
wire has been removed from the Locca Receiver
for any reason, carry out the following:
• Reveal the two conductors in the wire and use
a jeweller’s screwdriver to connect them to pins
5 and 6 of the connection block at the bottom
of the Receiver. It does not matter which way
round you connect the leads
• Connect the two connectors on the electric
door opening mechanism
• Pins 2 and 3 should be linked by the short wire
that is in place when you obtain your Receiver.
Ensure that this is the case.
Install the door release to the door frame,
as described in the separate instructions
(these are in the Electric Door Release packaging).
Step 3
Mount and plug in the
Locca Receiver
Screw the metal mounting plate onto the wall using
the screws and plugs provided. Slot the Receiver
onto the mounting plate.
There is a screw at the base of the Receiver that
you may tighten to prevent the Receiver being
lifted off the mounting plate.
Your Locca system is now installed.
If you need to personalise your system you may
do so now (see page 4: How to personalise
your system).
Screw metal
mounting plate
to wall
Tighten
screw at base
of Receiver
6 5 4 3 2 1
Pre-installed wire
should be connected
direct to connectors
on electric strike
Pre-installed
wire link
Locca Receiver