LP950 OPERATORS MANUAL
2
2 Installation
Printer
The LP950 printer should be installed at the appropriate mounting angle,
orientation and location to provide optimal conditions of use by the operator.
The following important rules should be observed:
1. The printer should not be located in direct sunlight or near any engine
compartments which can become excessively hot. (If necessary a
screen should be provided to shade the unit from direct heat and
sunlight).
2. To reduce the risk of entry of dust or moisture into the printer case -
•
The unit should be mounted with the mouth of the paper exit slot in
a downwards direction.
•
Care should be taken that externally accumulated dust, water and
oil etc. does not enter when the lid is opened to replace the paper
roll.
3. The printer should be located in such a way that it does not hinder the
normal operation of the machine controls or the visibility of the operator.
4. The printer should be located in a position where:
•
The hinged lid can be opened without restriction, for replacement of
the paper roll or ribbon cartridge. [The lid is secured with a sprung
(not hinged) plastic clip. Bending this clip back too far may result in
its breakage.]
•
The operator has easy access to the printer to operate the printer
controls.
