LNS QUICK LOAD SERVO S3 T BARFEED, Service Manual

Page: 34 / 152

MECHANICAL EQUIPMENT
SERVICE MANUAL – QL Servo S3-T
BARS OF DIFFERENT LENGTHS
Although the bar feeder can load bars of different lengths, it is recommended to place them on the magazine in decreasing
order of length and to center (A) them between the limiters so that they do not end up askew (B) .
BARS OF THE SAME LENGTH
The bar feeder can also be used as a loading magazine for piston rods, axes or forged parts.
INFORMATION
A corresponding interface is necessary, however, if the minimum loading
times are to be achieved. These options can be studied and discussed in
advance with the lathe manufacturer or with the distribution company.
If the parts are of the same length, it is possible to move the rear limiter to reduce the loading time.
• Lift the protection grid.
• Install a bar on the bar magazine, pressing against the front limiter.
•
Move the rear limiter 1 millimeter behind the bar.
Check the parallelism of the limiter by rolling the bar on the magazine.
• Tighten the retaining screws.
• Close the protection grid
•
Edit the corresponding parameter.
To facilitate movement of the bars on the magazine, the latter has been fitted with a grid onto which the bars are placed.
However, if certain bars (profiled bars, for example) have difficulty sliding, the gradient can be increased using an axis located
underneath the magazine. Conversely, if bars with a small diameter start to pile up, the gradient can be decreased.
PROFILED MATERIAL
Depending on the profile of the bars to be loaded, additional settings and accessories are required. Please contact LNS or
their local representative.