© 2014
LNR Precision Par EndFedz Antennas and QRP Transceivers
RIT
Receiver Incremental Tuning. This feature allows changing the frequency of the receiver only without effecting the transmit
frequency. When RIT is activated an
*
initially appears to the right of the frequency readout. The
*
indicates that currently,
RIT=0 or RX=TX.
While RIT is activated, tuning the VFO BELOW the current frequency is indicated by a
<
symbol.
Similarly, tuning above the center frequency results in a
>
symbol appearing to the right of the display.
RIT remains active until the next ON/OFF power cycle.
PRE/ATT
Sequentially enables preamp (
↑
) approx. +16dB
Preamp off= No arrow attenuator (
↓
) approx. -10dB
FILTER
Filter #4 is customizable in CW and SSB. CW from 50Hz
2400Hz SSB from Low end of 250Hz to High end of 3400Hz.
CW: Select Filter #4. Press F then Filter. Use the VFO knob to adjust bandwidth
SSB: Select Filter #4. Press F then Filter. Use the VFO knob to adjust the low end. Press RIT to adjust the High end. Pressing
RIT again will toggle back to low end adjust. Press Filter when complete.
Memory Storage
A total of 100 memories are available. All features (e.g. Mode/NB/NR/Preamp etc) are stored along with the frequency.
To store a frequency in memory, first tune it in using the VFO. Set Mode and any other features you wish to store. Press
MEMO Use the VFO knob to bring up the memory location you wish to store: 0-99
Press the Down Arrow
ꜜ
Press MEMO again
Memory Recall
To recall a stored memory channel;
Press MEMO
Use the VFO to dial up the desired memory location
Press the Up arrow
ꜛ
Press Memo again