Installation Instruction:
24V Static Color - LED Tapelight
www.llialighting.com
tel: 847-412-4880
REV0.0 07062022
page 4-5
2
Gripper
connect
pins
LED tapelight
LED to Wire
Gripper connector
2.1
Carefully open the cover to the Gripper connect.
2.2
Insert the LED tapelight into the Gripper connect. Make
sure the LED tapelight solder pads are sitting over the Gripper
connect pins.
2.3
Close the cover completely through the tapelight, if necessary
use pliers.
2.4
Repeat these steps if using the LED to LED Gripper connect.
3
4
3.1
Carefully open the wire cover on the LED to Wire Gripper
connect.
3.2
Insert two 18 or 22 AWG wire lead into the contact slots.
Followed by closing the cover, if necessary use pliers.
Make sure
the wire leads are cut flush prior to inserting into the Wire
Gripper connect.
4.1
Remove the red adhesive backing from the LED tapelight.
4.2
Carefully press the LED tapelight to the mounting surface.
If installing to a specific extrusion reference that installation for
more details.
4.3
Make the wiring connections in accordance with local & national
electrical codes.
For additional information reference the power
supply instruction. General wiring diagram on page 5.
3.1
3.2
4.1
4.2
cover
LED to Wire Gripper connect
2.1
LED tapelight
wire lead
2.2
2.3
2.4
LED tapelight
adhesive
backing
