Installation Instruction:
24V Static Color - LED Tapelight
www.llialighting.com
tel: 847-412-4880
REV0.0 07062022
page 3-5
Install the Hardwired Tapelight
Install the Gripper Connect
INSTALLATION NOTES:
•
Review all the parts and quantities to confirm if all the
necessary parts are available.
•
LED tapelight can only be cut at specific points. It is
essential to dryfit your entire assembly to the cut point
of your LED tapelight before routing/cutting out the
mounting surface.
INSTALLATION NOTES:
•
Review all the parts and quantities to confirm if all the
necessary parts are available.
•
LED tapelight can only be cut at specific points. It is
essential to dryfit your entire assembly to the cut point
of your LED tapelight before routing/cutting out the
mounting surface.
CAUTION:
Use the proper safety equipment when
making any modification to LED tapelight
CAUTION:
Use the proper safety equipment when
making any modification to LED tapelight
1
1
LED tapelight
adhesive backing
LED tapelight
LED tapelight
utility shears
utility shears
1.1
If shortening the LED tapelight, Cut along the cut marks that are
in between the solder pads using utility shears.
1.1
Shorten the LED tapelight to the desired length. Cut along the
cut marks that are in between the solder pads using utility
shears.
2
1.1
1.1
2.1
Remove the red adhesive backing from the LED tapelight.
2.2
Carefully press the LED tapelight to the mounting surface.
If installing to a specific extrusion reference that installation for
more details.
2.3
Make the wiring connections in accordance with local & national
electrical codes.
For additional information reference the power
supply instruction. General wiring diagram on page 5.
INSTALLATION NOTES:
•
Make sure not to cut the side of the tapelight with
lead wires.
2.1
2.2
INSTALLATION NOTES:
•
Reference either the Hardwire or the Gripper Connect steps to install the Tapelight properly.
