Installation Instruction:
24V Static Color - LED Tapelight
www.llialighting.com
tel: 847-412-4880
REV0.0 07062022
page 1-5
WARNING:
Do not connect directly to high voltage power (120V-277V). Use only with 24V DC hardwire or plug-in power supply. Factory warranty will be
void if used otherwise.
• Read complete instruction.
• These products may represent a potential shock or fire hazard if improperly installed or attached in any way. Products should be installed in accordance
with these instructions, local electrical codes and the National Electric Code (NEC).
• Do not energize LED tapelight when rolled up in its spool.
• Uncoated products are intended for indoor use in dry locations. Coated products are intended for outdoor use or in damp/wet locations. Refer to product
spec sheet for location ratings.
• Do not use if there is any damage to the unit or to the wiring/insulation. Inspect periodically.
• Do not route cords or LED tapelight through walls, doors, windows or any similar part of a building structure.
• Do not secure LED tapelight or its power cord with staples, nails, or any other sharp objects that may cause damage.
• Do not install LED tapelight closer than 6” to combustible material.
• Ensure proper gauge wires are installed between Power Supplies, Controls & LED tapelight to avoid voltage drop.
• Ensure applicable wires are in compliance with local codes (In-wall rated, wet-location, high temperature, etc.).
• Recommended load for power supplies is 80%.
!
SAFETY INFORMATION
• LED Tapelight
• Extrusion / Lens
• 24V DC Power Supply
• Connectors (if applicable)
√
required components to complete installation
