LKM LKM75X, Manual Relating To The System Components

Page: 14 / 49

13
8.8.2.5. Lost device Interval
In the case of radio systems, it may happen that a message is not received.
However, it is not always desired by the user to get an error message each time this
happens. This function allows the user to fix the time interval between the last radio
contact and the initiation of an error message. By pressing OK, this is confirmed. In
addition, also the type of error message can be determined by using the
corresponding button. After disconnection, the values are again saved.
8.8.2.6. Alarm relay
The receiver is equipped with a semi-conductor relay which permits 4 alarms to be
released in an easy way. When the button is pressed, the list of the transmitters
logged on is displayed. They can now be assigned to the respective alarm module by
means of the Drag and Drop function. The alarm is activated by placing a tick in the
„Alarm“ box. In addition, the user can fix whether a moisture or a temperature alarm
shall be released. If the transmitter selected does not have a moisture sensor, a red
exclamation mark is shown after the IEEE number when this number is selected. The
alarm is released if one of the 4 modules reaches the alarm value (or-link). For all
modules together, the user may decide whether the alarm shall be triggered when
the alarm value is either exceeded or when it falls below a certain level. If an IEEE
number of an alarm module is dragged to the Trash, it will be deleted. Clicking on
“Confirm settings”, the data are saved in „Changes to be saved“. They come into
effect by clicking on
„Disconnect“.
8.8.2.7. LCD module
Here, it is fixed whether 2 or 4 lines are displayed.
8.9. Language
Here, at present the user can choose between German and English.
8.10. Evaluation
Here, the values of the single transmitters shown in the table can graphically be
represented. Thus, it is well possible to get a quick overview of any trends in the
measurements.