User Manual for COLOSSUS Series Embedded Net DVR
LJD Digital Security Ltd
Page
94
of
107
Copyright © 2005. All rights reserved.
4.
In the “User/Rights Security” Dialog, select “User Name” as “target”. In “Home
Directory” edit box, input the path where the firmware file (digicap) is placed. Then press “Done”
to exit.
7.2 Upgrade
Mode
1.
Use client software to upgrade the firmware file. You do not need to use ftp server
software. Please refer to the client software user manual for detail information.
2.
Use “FTP” function of “Upgrade” sub menu in “Utilities” menu. You need one host PC
to run FTP server software and place firmware file (digicap), and make sure DVR and
PC are in the same sub net.
3.
Use “USB” function of “Upgrade” sub menu in “Utilities” menu. Please make sure the
firmware file (digicap) is placed under root directory of USB flash memory.
4.
After you reboot DVR, if you can only hear the startup sound, but can not see startup
picture, you can input shell commands under HyperTerminal. You need one host PC to
run FTP server and HyperTerminal software, and make sure DVR and host PC are in the
same sub net. Please use DTE cable to connect DVR will host PC.
Step 1:
Setup and run HyperTerminal
The parameters are: Baud rate: 115200bps, Data bit: 8 bits, Stop bit: 1 bit,
Parity: No, Flow ctrl: None.
Step 2:
Press "ctrl" and "u" keys of the PC keyboard. Do not release them.
Step 3:
Switch off and on the power supply of DVRDVS. In the HyperTerminal, the
following sentence is appeared:
Please input [u/U] or [ESC] key
Release "ctrl" and "u"
keys.
Step 4:
Press “u” key. In the message line of “
IP address of NET DVR
”, input any one
