- 2 -
2
M965743 Rev. 1.1 (11/18)
• Turn off hot and cold water supplies before beginning.
• Connect FLEXIBLE SUPPLY HOSES
(1, 2)
directly to wall
supplies. Connection on fitting supplies are 3/8
"
compression. Connect left supply hose (Red Stripe) to Hot
wall supply. Connect right supply hose (Blue Stripe) to Cold
wall supply. Use adjustable wrench to tighten connections.
Do not over tighten.
*
Faucet supplies are 32
"
long from faucet base.
•
Note: If additional supply length is required, installer
must purchase additional parts separately.
•
Important: If SUPPLY HOSES (1, 2) are too long,
loop as illustrated to avoid kinking.
MAKE WATER SUPPLY CONNECTIONS
RED
STRIPE
BLUE
STRIPE
1
2
COLD
HOT
3
4
5
STREAM (AERATOR)
SPRAY
3
CONNECT SPRAY HOSE AND INSTALL WEIGHTS
2
3
1
REMOVE
COLD
ON
OFF
HOT
7
6
8
2
1
3
4
5
• Push the SPRAY HOSE END
(1)
into the HOSE
CONNECTOR
(2)
and slide down the LOCKING
COLLAR
(3)
until it snaps into place.
• With HAND SPRAY
(4)
seated in SPOUT
(5)
, install
WEIGHT
(6)
at labeled area on HOSE
(7)
, secure
with SCREW
(8)
.
4
TEST INSTALLED FAUCET
• Turn ON water at main supply.
• With HANDLE
(1)
in “off” position, unthread SPRAY
(3)
from HOSE
(2)
.
• Operate handle back to front, in COLD and HOT positions, to flush water
lines thoroughly.
• Replace SPRAY
(3)
onto HOSE
(2)
.
SPRAY OPERATION
• With FAUCET on, press TOGGLE BUTTON
(4)
on SPRAY
(3)
to switch
from stream to spray.
• Press and hold PAUSE BUTTON
(5)
to temporarily stop flow from SPRAY
(3)
. Release PAUSE BUTTON
(5)
to resume flow from SPRAY
(3)
.
