Living Flame Eastside Euro, Installation Manuallines

Page: 13 / 62

OPERATING INSTRUCTIONS
ELECTRONIC TWO STAGE WITH
AUTO SPARK IGNITION
CONTROL OPERATION
•
Check gas supply is turned ON.
•
Check power supply is turned ON.
START UP
•
Turn both the on / off switch and the high / low
•
Switch to the ON position.
•
After the controller has completed a safety check (for some controllers this will take
approximately 8 – 10 seconds, others may take 30 – 35 seconds),
•
The auto spark ignition will start and a clicking noise will be heard.
•
The gas valve will open, the pilot will establish and the main burner will light.
•
If the pilot fails to light the gas supply will be shut off after 8 seconds.
•
Turn the control system to the off position and wait 30 – 60 seconds before restarting
the fire.
Note:
If the gas line has been interrupted or when first lighting the fire, it may be necessary to
follow the above start up sequence several times.
HIGH / LOW FLAME
Once the fire has reached full glow and temperature, the high / low switch may be turned off
to give the low fire effect. For high flame just turn the room switch back to on.
SHUT OFF
Turn the on / off room switch to the off position and the control system will shut off the pilot
and main burner.
SAFETY SHUT OFF
The Electronic Control System will automatically shut down should the pilot be interrupted or
the pilot fail to light. To re-set the control system, turn the room switch to the off position and
wait 30 – 60 seconds before the fire can be re-started.
If the system fails to light after several attempts, call for a registered Living Flame
Maintenance Engineer or Living Flame Auckland for your nearest registered service
organisation.