SECTION 4: CARE & MAINTENANCE
SECTION 4: CARE & MAINTENANCE
CAUTION
- To prevent permanent damage to the warming drawer surfaces, do not use abrasive
cleaners or scrubbers.
- Do not allow acids or acidic products to remain on the warming drawer’s surfaces.
The finish may stain.
- Always wipe stainless steel surfaces in the direction of the grain.
DANGER: RISK OF ELECTRIC SHOCK
Always unplug this furnishing from the electrical outlet before cleaning.
Cleaning & Ongoing Maintenance
6
7
Category
Cleaning Recommendation
Electronics/
Control Panel
Anti-static electronic aerosol dusters can be used to keep the surfaces of
electronic components, power cables, and plugs free of dust. Exercise caution
to avoid introduction of liquids into the area behind the control panel. Do not
use abrasive cleaners or scrubbers. They may permanently damage the finish
or damage the letters and/or graphics.
Drawer Face/
Drawer Handle
Clean the drawer face/handle with a solution of mild detergent and hot wa-
ter. Rinse and dry with a soft cloth. You may also use a stainless steel cleaner.
Use stainless steel cleaner according to the directions on the package. Always
wipe stainless steel surfaces in the direction of the grain.
Drawer Interior
Clean the drawer interior with a solution of mild detergent and hot water.
Rinse and dry with a soft cloth. Do not use any flammable cleaners inside the
warming drawer.
Painted
surfaces
Clean any painted surfaces with a solution of mild detergent and hot water.
Rinse and dry with a soft cloth. Do not use abrasive cleaners or scrubbers.
They may permanently damage the finish.
Gasket
The gasket is located around the edge of the drawer opening, below the
control panel. Gently clean the gasket with a solution of mild detergent and
hot water. Rinse and dry with a soft cloth. The gasket material is soft, so be
careful not to crush or damage it. Damaging the gasket will cause a poor heat
seal and result in poor warming drawer performance.
When heating moist towels, condensation can build up inside the drawer. If not regularly wiped
down, this can lead to small amounts of water dripping from the warming drawer when opened.
To minimize any water dripping, ensure you perform the following maintenance tasks as needed
throughout the day:
1) Ensure any condensation and/or moisture (inside and outside the drawer) is wiped dry with a
soft cloth as needed.
2) Ensure any condensation and/or moisture on the surrounding wood and/or laminate is wiped
dry with a soft cloth as needed.
Push in locking tab
(on both sides of drawer)
Pull up on
drawer face
1. Pull the drawer out to the fully open position.
2. Push in the locking tab on one side, and pull up on the drawer face.
3. Once the drawer is loose, repeat process on the opposite side.
4. Grip the drawer on both sides and pull it up and out from the glides.
5. For safety reasons, push both drawer glides back into the drawer until ready to re-
install the drawer.
Allow the warmer to cool for a minimum of 30 minutes before at-
tempting to remove it the drawer.
Always unplug the table/trolley the warming drawer is embedded into
from the electrical outlet before cleaning.
Removing the Drawer
