Living & Co CM5018D-GS, Instruction Manual

Page: 11 / 16

Note
: After steaming, allow the coffee maker to cool down at least for 5 minutes before making
coffee again, otherwise a burnt odour may be noticeable in the prepared coffee. If you want to make
coffee immediately: press and release the coffee/ steam button and dip the steam wand into a cup.
Press the pump on/off control button down and turn on the steam control dial; water will flow out
from steam wand. After the ready temperature indicator, press and release the pump control button,
then turn the steam control dial to “ 0 ” position. When the ready indicator illuminates, the appliance
is prepared for making coffee once again.
FROTHING MILK / PRODUCING STEAM TO HEAT LIQUIDS
The steam wand can be used to froth milk and make hot beverages like drinking chocolate, water or
tea.
Method:
1. Remove the water tank and fill it with desired amount of water. The water level should be
between the “MAX” mark and the “MIN” mark in the tank. Re-insert the tank into the appliance
securely.
2. Connect the appliance to the wall socket.
3. Press the ON/OFF button “ ” to turn on the unit; the power indicator will illuminate in red.
4. Press down the pump on/off control button
“ ”
, the pump will activate and water will begin to
flow from the portafilter. Once water flows, push the pump on/off control button again to switch
off. The purpose of the step is to pump the water from the tank into the housing heating
chamber. the coffee temperature indicator light (green) will activate
5. Press down the coffee/steam on/off button “ ” , the appliance will begin preheating until the
coffee temperature indicator (green) illuminates, indicating that the preheating process has
completed.
6. Dip the steam wand into the liquid to be heated. If you want to froth milk, dip the steam wand
about 2 centimetres into the milk. Slowly turn the stand dial anti-clockwise to start making
steam.
7. When the required amount of frothing is reached, you can turn the steam dial to the “0” position.
8. To avoid the steam outlet being blocked after frothing milk each time, put an empty jug under
the steam wand, then turn on the steam dial and press the pump on/off control button
“ ”
.
The pump will begin operating. Once the water has been flowing for 30 seconds, press the
pump control on/off button
“ ”
to switch off.
9. Let the components cool down completely, then rinse under running water. Ensure the steam
wand / nozzle is thoroughly cleaned after each use. Remove the steam wand cover (tube) and
rinse, while cleaning the internal nozzle with a wet towel.
10. Press and release the ON/OFF button to power the unit off.
9