LIVARNOLUX 10346A, Assembly, Operating And Safety Instructions

Page: 10 / 46

9 GB
Replacing the
rechargeable battery
The batteries should be replaced every 12 months
to ensure optimum performance.
10346A/B:
Remove the lampshade
1
from the lamp
body
3
.
Pull the solar cell housing
2
out of the
lampshade
1
.
Switch off the light using the ON/OFF switch
7
by setting the switch to the „OFF“ position.
Remove the fastening screws
8
using a small
cross-tip screwdriver. Then open the battery
cover on the solar cell housing
2
using a flat-
head screwdriver.
Replace the old battery
10
with a new re-
chargeable battery, taking care not to damage
the cables. Please note the polarity when in-
serting the battery. This is shown inside the bat-
tery compartment
9
. Use only rechargeable
batteries of the recommended type (see
„Technical Data“).
Close the battery cover and tighten the retain-
ing screws
8
using a small cross-tip screw-
driver. Set the ON/OFF switch
7
to the
„ON“ position.
Reattach the solar cell housing
2
to the lamp
shade
1
. Then assemble the remaining parts
of the lamp.
10346C/D:
Remove the lampshade
1
from the lamp
body
3
.
Turn the solar cell housing
2
out of the
lampshade
1
counter-clockwise.
Switch off the light using the ON/OFF switch
7
by setting the switch to the „OFF“ position.
Remove the fixing screws
8
using a small
cross-tip screwdriver.
Replace the old battery
10
with a new re-
chargeable battery, taking care not to damage
the cables. Please note the polarity when in-
serting the battery. This is shown inside the bat-
tery compartment
9
. Use only rechargeable
batteries of the recommended type (see
„Technical Data“).
Tighten the retaining screws
8
with a small
cross-tip screwdriver. Set the ON/OFF switch
7
to the „ON“ position.
Reattach the solar cell housing
2
to the lamp
shade
1
. Then assemble the remaining parts
of the lamp.
10346E/F:
Pull the solar cell housing
2
off the lamp
shade
1
.
Switch off the light using the ON/OFF switch
7
by setting the switch to the „OFF“ position.
Use a small cross-tip screwdriver to remove the
fastening screws
8
.
Replace the old battery
10
with a new re-
chargeable battery, taking care not to damage
the cables. Please note the polarity when in-
serting the battery. This is shown inside the bat-
tery compartment
9
. Use only rechargeable
batteries of the recommended type (see
„Technical Data“).
Tighten the retaining screws
8
with a small
cross-tip screwdriver. Set the ON/OFF switch
7
to the „ON“ position.
Reattach the solar cell housing
2
to the lamp
shade
1
.
Charging
Please note, the solar garden light must be
switched on when the battery is charging. The
charging time via the solar cell varies by the inten-
sity of the sunlight and the incidence angle of light
onto the solar cell. Place the solar cell as perpen-
dicular as possible to incidence angle of light. This
will ensure the brightest light.
Maintenance and Cleaning
The LEDs cannot be replaced. The solar lamp is
maintenance-free, except for any necessary
change of battery.